Signaline HD analogue heat sensing cable must be used with a Signaline HD controller and End of Line Unit. These enable the Signaline HD heat sensing cable to be fully monitored for open and short circuit. The controllers are equipped with volt free fire and fault relays that are connected to the fire control panel via an Interposing Line Unit. Alternatively the Controller can be used as a stand alone device using the relay contacts to activate subsidiary equipme
Easy and economical to install
Very simple to set up and operate
Controller will monitor up to 500 m
of sensor cable (dependent on ambient temperature)
The sensor cable is resistant to corrosion and moisture and can be reset after use
Signaline-HD-SKM-03 and Signaline-HD-SKM-95 are VdS approved EN 54 part 5 & 17
Designed for fire detection systems requiring local indication of an individual or group of fire detectors in alarm mode, the VRLU indicator utilises an ultra-bright LED with a wide range of illumination.